3D-printed space maintainer for lost baby molars
Part of Mouth & dental clinical trials.
This study tests a 3D-printed space maintainer (like a small partial denture) for children who have lost a lower baby molar early. It helps keep space for the permanent tooth to come in properly.
Summary written for real people, not researchers, by Clin2.
Who can take part
- Your child must have recently lost a lower baby molar (within the last 3 months).
- The permanent tooth underneath should not be ready to come in for at least 6 more months.
- Your child needs to have normal bite and jaw alignment, with no crossbite, open bite, or deep bite.
- There should be teeth on both sides of the gap where the baby tooth was lost.
- Your child should be cooperative and able to tolerate dental procedures.
- Your child must not have habits like thumb sucking, teeth grinding, or severe crowding.
Quick eligibility check
Answer a few plain-language questions, based on this study's own requirements, to get a preliminary sense of fit.
Similar studies
Other trials that look related to this one.
This study compares two types of dental devices that hold space in a child's mouth after baby molars fall out early. The research tests whether a newer 3D-printed version works as well as or better than the traditional wire-based device.
This study looks at what happens to the space in a child's mouth when a lower first baby molar is lost early due to decay. It uses a digital scan to measure changes, which could help decide if a space maintainer is needed.
This study compares three different types of devices that keep space open in a child's mouth after an early primary (baby) tooth is lost, so the permanent adult tooth can come in properly. Your child will be randomly assigned to receive one of the three types and will be followed to see which works best.
This study tests two types of tooth-colored space maintainers (PEEK and BruxZir) in children who lose both lower first baby molars. The goal is to keep the space open for the permanent teeth to come in properly.
This study compares two types of space maintainers (prefabricated versus custom-made) for children who need a lower baby molar removed. The goal is to see which type lasts longer and works better to keep space for the permanent tooth.
This study tests a new 3D-printed expander that attaches to bone to widen a narrow upper jaw in young adults. It may help if you have a crossbite or need more room in your upper jaw.
Hear when a new Space Maintenance trial opens
We’ll email you when one opens — at most once a week, no account needed, unsubscribe anytime.